Samoa 391 010 Bedienungsanleitung Seite 5

OPERATION
INK SUPPLY
!
WARNING: Check if there are any dents on the drum, they
could block the follower plate of the ram inside the drum.
Once the pail is installed, to start discharging ink proceed to:
• Open the bleed air valve (13). The pump can now expel any air trap-
ped in (fig. 9).
• Start the pump opening the pumps valve (pos. 4), and increasing the
pressure with the regulating filter gradually (pos. 9). The pump starts
operating. Be aware that the pressure in the pump is the air line one
(fig. 10).
• Close the pump air bleed valve (13) as soon as the material trapped
air is pumped out of the valve (fig. 9).
13
Fig. 9
!
WARNING: While the equipment is connected to the air line, be
aware of the danger of being trapped by the mobile elements of
this equipment.
For your own security and to prolong your pumps lifetime
unplug the air inlet coupler after using this equipment.
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
!
WARNING: Not dry run the pump: it could damage the
pneumatic motor and ruin the seals
1
4
12
Fig. 10
EN
9
5
R. 02/22 854 804