System Parts; Image Modalities - Optos Daytona P200T Benutzerhandbuch

2.6.1 System parts

FIGURE 1: P200T device connected to network
No. Name of Part
1 Scan head
Face pad, eye
2
piece
3 Status indicator
4 Touch screen
5 Image server
6 Customer network
Patient
7
environment
Note
The device also includes a user guide, dust cap, power cable and Cat 6 cable not shown on this diagram.
A table may also be supplied.

2.6.2 Image modalities

Optos multi-modal ultra-widefield retinal imaging enables the capture of posterior images, with a field of view of
up to 200 degrees in a single capture, and in an imaging time of less than 0.4 seconds.
Part Number: G102748/9GWE
Copyright 2017, Optos plc. All rights reserved.
(Daytona shown)
Description
The scan head comprises the light sources and electronics used to capture
patient images.
These parts help support the patient when the patient is being imaged.
The color changes to show the status of the device, see Status indicator on
page 42.
The touch screen monitor is used to interact with the system. It displays
alignment feedback and captured images.
Runs software and lets you manage the networked images. The image server will
also let you review and analyze patient images.
Switches, Firewalls, Internet access, Review clients, Virtual image server (if
required)
The image server, switch, browser-based review clients and any Viewing PCs or
monitors must be positioned outside the patient environment; more than 1.5
meters (5 ft) from the scan head.
Chapter 2 - Introduction
Page 23 of 65
English