Important Tips - Livington INSTACHILL Gebrauchsanleitung

POWER
Press the On/Off symbol on the control panel or the remote control
to turn on the air cooler. Its light illuminates. Press this symbol again
to turn off the device. Its light will turn off.
SWING
Press the swing symbol on the control panel or on the remote
control to automatically pan the vertical front grille, and the
corresponding light will turn on. Press this symbol again to stop
the swing mode, and the light will turn off. The rear grilles can
be adjusted manually to direct the air flow from top to bottom as
needed.
SPEED
Press the speed symbol so that the fan with the lowest speed (1)
starts up. Press the symbol on the control panel or on the remote
control again to switch the speed between low (1), medium (2) and
high (3).
ANION
Press the anion symbol on the control panel or on the remote
control. To stop the anion mode, press the symbol again. ANION is a
system to kill the bacteria in the water tank. The anion function adds
a negative charge to the water, which inhibits the growth of bacteria
and other pathogens, and attracts dust. The function corresponds to
that of an air cleaner.
Cleaning & Maintenance (3-piece special filter)
1. Remove the cover (J) from the back - remove the safety
screw with a screwdriver (remembering to screw it back on
afterwards).
2. Pull out the special filter in the direction of the arrow (1).
3. Removing the special filter from the front opening: Hold the
housing with one hand. Gently pull it with the other hand on one
side and up out of the frame (2).
4. Regularly clean the special filter with ordinary water and wipe off
any dirt with a soft brush or cloth (3).
5. Pay attention to the dimensions when inserting the filter. The
filters are different sizes and must be fitted
correspondingly. You will see that the
filters have an irregular shape on the upper
side. This must always point upwards when
inserting. If the filters are very dirty, they
should be replaced: with regular use this
should be at least every 6 months.
Note: If de-scaling is required, make sure that you remove the
filters beforehand.
M21360_M27532_Livington InstaChill_Manual_20220215_MM.indd 8 M21360_M27532_Livington InstaChill_Manual_20220215_MM.indd 8
1
TIMER
Press the timer symbol on the control panel or the remote control to
set the timer. The setting changes with every press of the symbol.
From 1 to 7 hours, in ascending order. To turn it off, press again.

IMPORTANT TIPS:

• The cooling function works best at low humidity. If there
is a very high level of humidity, the temperature cannot be
significantly reduced.
• Use cool, fresh water with each use. The colder the water, the
greater the cooling effect. Small ice cubes can also be added to
the water to improve the effect even further.
• Switch off the cooling function („Cool") 20 to 30 minutes before
switching off and allow the unit to continue running so that the
cooling pads can dry. This helps avoid bad odours, deposits and
mildew.
• Note: When you turn on the unit, the cooling function (water
being pumped to the filters) does not automatically activate. The
cooling symbol must be pressed each time after switching on.
2
WATER DRAINAGE CAP
To remove the water from the unit, place a container below the water
drainage cap (K) on the lower part of the rear of the unit, or place it
in the shower/bathtub. Then carefully open the water drainage cap
(K), ensuring that no water spills over so as not to damage the floor.
8
3
Made in China
15.02.22 07:25 15.02.22 07:25