How To Install; Step 1: Where To Install - SELFSAT IP 36 Bedienungsanleitung

How to Install?

You will be able to install SELFSAT>IP series easily by yourself by following this
manual step by step.
Before installing your antenna, you have to check that SELFSAT>IP series box contains all the items
listed above in the 'Box Content'. In the event of any missing parts, please contact your distributor.

Step 1: Where to Install?

In order to receive a signal from the Satellite, SELFSAT>IP series has to be installed in an open loop space
(outside the house or the apartment), in the direction of the satellite towards the equator, for which, you
will need a compass to exactly orient SELFSAT>IP series toward the satellite.
Note
Please take reference to the table of the Azimuth angles specified in the back pages of this manual.
< Compass >
Note
To ensure an accurate compass reading, stay away from large metal objects, specifically electrical
cables and then make multiple readings.
Make sure that there are no obstacles in front of SELFSAT>IP series which can decrease the signal
reception quality, such as buildings or trees (you may keep in mind that trees will grow and may block
the signal).
In order to be able to fix and install your antenna easily, you might choose an easy accessible place
without any potential danger for installation.
Think about the way you prefer to place your cable in a discreet way from the SELFSAT>IP series to your
Set top Box. The antenna should not be too distant from your satellite receiver; a cable longer than 30
meters may decrease the quality of the signal.
Bad Quality Signal Reception
N 0˚
S 180˚
Good Quality Signal Reception
Satellite position
Azimuth Angle
5