Hilti Nuron NPR 32 XL-22 Original Bedienungsanleitung Seite 31

3. Rotate the locking pins counterclockwise as far as they will go.
▶ The locking pin pops out.
4. Remove the crimping/pressing/adapter jaw forward and out of the product.
5.7 Fall arrest
WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether for possible damage.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only the Hilti tool tether #2261971.
▶ Use the loop to secure the tool tether to the product
as shown in the illustration. Check that it holds
securely.
▶ Secure the carabiner to a load-bearing structure.
Check that the carabiner holds securely.
Comply with the operating instructions of the
Hilti tool tether.
6 Operation
DANGER
Electric shock hazard! Working in adverse outdoor conditions can cause electric shocks and/or short
circuits.
▶ Never work on electrically live lines while a thunderstorm is in progress.
▶ Call a halt to work immediately whenever weather conditions impair the insulation characteristics, vision
or movement of the workers.
WARNING
Risk of injury due to oil escaping under high pressure! Oil escaping under high pressure can injure the
skin and the eyes.
▶ Do not use the pressing tool if damage is visible.
▶ Do not use the pressing tool if oil escapes.
▶ Make sure that the piston retracts after every pressing operation.
▶ If the piston does not retract after the pressing operation, press the reset button for manual retraction.
WARNING
Risk of injury by escaping gas! Escaping gas can injury the respiratory system or ignite.
▶ Perform pressing operations on gas-pipe systems only with specially tested and suitable combination of
pressing tool and fitting which, moreover, has the express approval of the system supplier.
WARNING
Risk of injury due to flying fragments! Flying fragments present a risk of injury to the eyes and body.
▶ Wear eye protection and protective gloves.
▶ Use suitable connecting material in combination with the correct pressing rings and pressing / adapter
jaws.
▶ Before and during the pressing operation, make sure that the pressing rings and pressing / adapter jaws
are correctly positioned.
*2321727*
2321727 English 25