Available Measurements And Product Description - Uniks EV CHECK Benutzerhandbuch

Available Measurements and Product Description

4.
• The adapter can test the electrical safety and function test of mode 3 electric vehicle charging equipment (EVSE)
with type 2 connector (or optional type 1 connector).
• PE Pre-Test (potential presence of dangerous voltage at PE. terminal by mistake)-touch electrode and led lamp.
• phase indicator(presence of all three phase voltages measured to N)-three led lamps.
• PP state simulation (NC,13A,20A,32A,63A)-rotary switch.
• CP state simulation (A,B,C,D)-rotary switch.
• CP error "E" simulation (cp signal short-circuited to PE)-push button.
• PE error (earth fault)simulation (interruption of PE conductor)-push button.
• Measurements on live conductors (L1,L2,L3 and n)and on PE conductor -five 4 mm safety sockets for connection
to installation testers.
• Test of cp signal-two 4mm safety sockets for connection to an oscilloscope.
• Mains socket (on backside) to connect an external load for test purposes only.
EV CHECK
23