EuroLite AKKU PLL-168 WW/CW Panel Bedienungsanleitung Seite 30

Dimmer
Menu point diMM allows the adjustment of the total brightness for all stand-alone operating modes: Stat,
Auto, Soun, Colo.
3 Press the MENU button so many times until diMM is indicated in the display. Confirm with the ENTER
button.
4 Use the buttons UP and DOWN to adjust the desired brightness (dI 1 = dark, dI 9 = bright). Confirm with
the ENTER button.
Strobe effect
The mode FLAS activates the strobe effect. The desired flash rate can be set.
1 Press the MENU button so many times until FLAS is indicated in the display Confirm with the ENTER
2 Use the buttons UP and DOWN to adjust the desired speed (0 - 9). Confirm with the ENTER button.
Behavior at missing DMX-signal
In DMX lost mode the program offers different options when no DMX signal is received.
1 Press the MENU button repeatedly until the display shows the DMX lost menu. Press ENTER to
confirm.
2 Select the desired program with the UP and DOWN buttons (see Menu structure). Confirm with ENTER.
Interconnecting several devices (master/slave operation)
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1 Configure all slave units before connecting the master unit: Press the MENU button so many times until
SLAU is indicated on the display. Confirm with the ENTER button.
2 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3 Set the master unit to the desired operating mode. The interconnected devices will now operate
synchronously.
Energy-saving mode
This mode offers the possibility to adjust the battery life.
For example:
Extra bright operating mode: 3 hours
Normal operating mode: 6 hours
Energy saving mode: 8 hours
1 Press the MENU button so many times until batt is indicated in the display. Confirm with the ENTER
button.
2 Use the buttons UP and DOWN to choose the desired setting (SuPE, norM, Econ) and confirm with the
ENTER button.
Potentiometer
This mode activates the rotary dials to manually set the color temperature and brightness.
1 Press the MENU button so many times until PotE is indicated in the display. Confirm with the ENTER
button.
2 Use the buttons UP and DOWN to select ON (manual setting activated) or OFF (manual setting
deactivated). Confirm with the ENTER button.
30/36 00137990.DOCX, Version 1.0