HP Stitch S1000 126in Einführende Informationen Seite 5

Heat hazard
The drying subsystem of the printer operates at high temperatures and can cause burns if touched. LED array
(optional) supports, beam, and enclosures can reach high temperatures. To avoid the risk of burns, take the
following precautions:
Do not touch the internal enclosures of the printer's drying module.
●
Take special care when accessing the substrate path.
●
Take special care with zones marked with warning labels.
●
Do not place objects covering the LED array supports, beam, or enclosures.
●
Do not attempt to modify the LED array supports, beam, or enclosures.
●
Remember to let the printer cool down before performing some maintenance operations.
●
Mechanical hazard
The printer has moving parts that could cause injury. To avoid personal injury, take the following precautions when
working close to the printer.
Keep your clothing and all parts of your body away from the printer's moving parts.
●
Avoid wearing necklaces, bracelets, and other hanging objects.
●
If your hair is long, try to secure it so that it will not fall into the printer.
●
Take care that sleeves or gloves do not get caught in the printer's moving parts.
●
Avoid standing close to the fans, which could cause injury and could also affect print quality (by obstructing
●
the air flow).
Do not touch gears or moving rolls during printing.
●
Do not operate the printer with covers bypassed.
●
Take care when using the air gun. When used for cleaning purposes, make sure to use it according to local
●
regulations, as additional safety provisions may apply.
Take care when handling the output cover. There is a risk of trapping your fingers. If you need to open or
●
close it, handle it only at the center, hold it firmly and move it slowly.
Be careful when you open the loading table, and never leave it unattended with both latches in the open
WARNING!
position. It may open inadvertently and cause serious injuries. Always check it has both latches closed properly.
Make sure you use protective gloves (PPE) when installing the Ink collector.
WARNING!
Light radiation hazard
Light radiation is emitted from the illumination of the print zone. This illumination is in compliance with the
requirements of the exempt group of IEC 62471:2006: Photobiological safety of lamps and lamp systems. However,
you are recommended not to look directly at the LEDs while they are on. Do not modify the module.
Chemical hazard
See the safety data sheets available at
Consumables. Sufficient ventilation needs to be provided to ensure that potential airborne exposure to these
substances is adequately controlled. Consult your usual air conditioning or EHS specialist for advice on the
appropriate measures for your location.
For more detailed information, see the "Ventilation" and "Air conditioning" sections in the site preparation guide,
available at: http://www.hp.com/go/StitchS1000126in/manuals.
4
http://www.hp.com/go/msds to identify the chemical ingredients of your
ENWW