MACAP M42 Serie Anleitung Seite 26

10-6 PROGRAMMING
Switch on the appliance to enter the programming menu. After the welcome message, press the select button (10 seconds
or until the wording on the display changes).
Scroll through the menu by turning the select button. When the function to be changed is displayed, press it to enter and
change the parameters.
To exit the programming menu, turn the select button, and when the wording "EXIT" appears on the display, press it to
confirm and return to the operating menu.
10-6-1 PROGRAMMED DOSES
To enter the programming menu, turn on the appliance. After the welcome message appears, press the select button (10
seconds or until the wording on the display changes).
The appliance has digital dose adjustment.
Scroll through the programming menu by turning the select button. When the dose to be adjusted is displayed, press it to
start programming.
Turn the select button to adjust the time shown on the display. The time will increase when it is turned clockwise and
decrease when it is turned anti-clockwise.
When the required time has been set, press the select button to confirm the value and return to the programming menu.
Proceed with adjusting the next dose.
The software is equipped with three programmable doses. Dose No.3 can be disabled (OFF) by turning the select button
anti-clockwise.
10-6-2 (CONTINUOUS DOSE)
To enable or disable the continuous dose, proceed as follows: scroll through the programming menu by turning the select
button. When the Dose symbol is displayed, continue pressing it to enter.
Turn the select button to enable or disable the function. Then press it to confirm and return to the programming menu.
From the operating menu you can now choose the continuous dose, if enabled.
The appliance can only operate in the continuous dose mode for short periods. Never exceed the time of one minute
continuously in order to prevent the motor from overheating.
10-6-3 DOSE COUNTER
The appliance has a feature to control the number of doses for the timed functions. The letter "P" indicates the number of
partial doses and "T" indicates the number of total doses. To reset the partial dose counter, enter programming and view
the dose counter function. Press the selection button and rotate it to position the cursor over the partial you want to reset.
Press the selection button until the value "0" appears in the partial counter. Press the selection button to leave the dose
counter function and return to the programming menu.
10-6-4 SETTINGS
If selected, the settings function opens a programming submenu.
10-6-5 D.T.S. (DOSING TYPE SELECTION)
The D.T.S. function allows you to decide how to select the dose.
- In Standard mode, selection takes place by using the select button to scroll through the functions set in the operating menu.
- In the Push and Grind mode, selection takes place directly using the dosing button.
Press the appliance once to start dose No.1, twice for dose No.2 and three times for No.3, if enabled.
The maximum selection time is 2 sec.
To select the continuous dose, if enabled, press the select button.
To set the D.T.S., scroll through the programming submenu (settings), turning the selection button. When "D.T.S." appears,
press to enter.
Turn the selection button to switch from one function to the other and then press it to confirm and return to the
programming submenu.
26
ENGLISH