Adjusting The Balance; Battery Installation - Echo DSRM-2600 Bedienungsanleitung

Adjusting the balance

Adjusting the shoulder harness
 This product is designed to fit a wide variety of body sizes, but may not be adjustable for extremely tall persons. Do
not use the unit if your feet can reach the cutting attachment when the unit is attached to the harness.
 A person's size can affect the balancing adjustment. Also the balancing procedure may not work with some units on some
persons. If the shoulder harness does not fit you or cannot be adjusted well, please ask your dealer for assistance.
Balance tool for a level plane of cutting head rotation

Battery Installation

 The attachment will operate when the battery is installed, the power indicator LED is lit, and the trigger and trigger
lockout are engaged. Make sure the unit is properly positioned to prevent loss of control and possible serious injury.
Keep movable parts of the attachment off the ground and away from objects that could become entangled or thrown.
 Remove the battery when leave the unit.
WARNING
IMPORTANT
 The accompanying shoulder harness is suitable for people of
standard adult physique, who are 150 cm - 195 cm in height
and 60 cm - 140 cm in waist size.
 Use a shoulder harness when provided or when recommend-
ed in this manual. Adjust both harness and the suspension
point (A) on the unit so the unit hangs with the cutting attach-
ment a few centimetres above ground level (B).
 The cutting attachment and shield should be level in all direc-
tions. Harness the unit on the right side as shown.
 Slide suspension point up and down the tube to find the right
balance. Rotate the clamp to level the cutting attachment and
shield. Lock in position. If the suspension point is a free-spin-
ning type, the unit may tend to roll over sideways, however,
you should still level the attachment and shield on the front-to-
rear axis.
 Balancing and levelling, as above, may require relocation of
the clamp and readjustment of the harness straps. Also, each
type of cutting attachment and shield mounted on the unit may
require balancing.
WARNING
1. Make sure power to unit is turned off.
2. Align ridges (A) on battery pack with grooves in power head.
Slide battery pack into power head.
3. Assure the battery pack latch (B) snaps into place and bat-
A B
tery pack is secure before beginning operation.
C
4. To remove battery, depress battery pack latch release (C)
slide battery pack out of power head.
 Battery pack latch is in the complete position when battery
pack latch is correctly engaged.
13
Before you start
NOTE