Electrical Interconnection; Before Connecting - ESX Vision VX 8000 PRO Benutzerhandbuch

ELECTRICAL INTERCONNECTION

BEFORE CONNECTING

For the professional installation of a sound system, car audio retail stores offers appropriate wiring kits. Ensure
a sufficient profile section and a suitable fuse rating and the conductivity of the cables when you purchase
your wiring kit. Clean and remove rust-streaked and oxidized areas on the contact points of the battery and the
ground connection. Make sure that all screws are fixed tight after the installation, because loose connections
cause malfunctions, insufficient power supply or interferences.
Turn-on cable to the head
unit (car radio)
max. total length of 2.0 m
ADDITIONAL
BATTERY
Not included in the scope of delivery
+12V
1
Connect the 12 volt terminals of the amplifier to the positive poles of the power capacitors by using
suitable cables. Then connect the positive poles of the power capacitors to the 12 volt positive pole
of the additional battery.
ATTENTION: Use for both connections sufficiently dimensioned cables of at least Ø 50 mm
tal length of max. 2 meters. If you use longer cables, the cross-section must be correspondingly larger.
Use very short cable lengths from the amplifier to the power capacitors, which should be mounted
close as possible to the amplifier.
18
Min. Ø 50 mm
max. total length of 2.0 m
Min. Ø 50 mm with a
2
< 30 cm >
ENGLISH
with a
2
INPUT
SENS.
HIGH VOLTAGE
1.0 - 9.0 V
LOW VOLTAGE
0.4 - 3.6 V
1 2 3
4
6
5
6
Min. Ø 50 mm
max. total length of 2.0 m
4
Min. Ø 50 mm with a
2
max. total length of 2.0 m
with a
2
with a to-
2