Installation Instructions - NORAUTO DX DR-211BT Bedienungs- Und Sicherheitshinweise

18. Before connecting the unit, check that:
- The unit and its components are undamaged. If any damage is noted, do not
use the unit, return it to the vendor for inspection and repair.
- The voltage indicated on the unit's specification plate corresponds to your
vehicle.
19. Do not disassemble the unit yourself. It must only be disassembled, repaired or
inspected by a suitably qualified person.
20. The car audio system must be used only in vehicles with a 12 V DC supply. Do not
connect the unit to other systems (e.g. 6 V DC or 24 V DC).
21. Local laws may restrict the use of this unit while driving and may sanction any misuse.
Always abide by applicable laws and follow the highway code when using this unit.
22. Do not use the unit in unsafe driving conditions (bad weather, dangerous roads, dense
or difficult traffic, etc.).
23. Take care if this unit is used while driving. Do not let yourself be distracted or disturbed
by this unit while driving. Lack of concentration may cause an accident. Remember
that you are in control of and responsible for the vehicle that you are driving.
24. Keep the volume at a suitable level. Excessive volume may prevent you from hearing
noises from your surroundings, which may result in a risk of accidents.
25. Prolonged exposure to high volumes (especially with headphones) can damage your
hearing. Avoid setting the volume too high or using the unit for too long.

INSTALLATION INSTRUCTIONS

1. The device is designed to be powered by 12 V direct current. Before installing the
unit, check that your vehicle has a 12 V power supply with the negative pole going to
ground.
2. The negative pole of the battery must be disconnected before the device is connected.
This reduces the probability of damaging the device by an accidental shorting of the
circuit.
3. Check that the unit is correctly connected according to the coloured leads based on
the wiring diagram. An incorrect wiring connection could cause the malfunction of the
unit or damage to the vehicle's electrical system.
4. Do not forget to connect the loudspeaker lead marked (-) to the (-) terminal. Never
connect the left and right loudspeaker leads together or to the car body.
5. Do not cover the ventilation openings on the unit. Blocking them will increase the
temperatures inside the unit, which may damage it or cause a fire.
6. This device can playback MP3 and WMA digital sound file formats.
7. Do not attempt to repair the unit, modifications to the unit may cause a malfunction
or damage the device.
8. Stop the vehicle before performing anything that could interfere with driving.
9. Do not turn on the device in extremely high or low temperatures. The normal
operating temperature is between -10 and +50 °C.
ATTENTION
Ensure correct connection, particularly the power supply (larger draw)
and backup memory (smaller draw). This will keep the current draw in
the turned off state to a minimum and maintain your set preferences in
the car radio memory.
EN
35