Xiaomi Roborock S7 MaxV Plus Bedienungsanleitung Seite 12

Using the Disposable
B4
Dust Bag
Note: The disposable dust bag uses a one-time seal design
to effectively prevent dust from spreading outward during
replacement. If you do not want to discard the dust bag, do
not pull out the seal. If the seal is pulled out, it cannot be
restored to the original state, which will affect the use of the
dust bag.
B4-1— Remove the dustbin vertically as
indicated by the arrow.
B4-2— Press the Dustbin Opener to open
the bottom lid of the dustbin. Rotate
the cyclone separator as shown to
remove it.
B4-3— Rotate the dust bag holder as
shown to install it until you hear it
click in place.
B4-4— Install the disposable dust bag in
place along the slot.
B4-5— Close the dustbin and place it back
in the dock.
Pause
When the robot is running, press any
button to pause it, press the
resume cleaning, press the
send it back to the dock.
Note: Placing a paused robot on the dock manually will end
the current cleanup.
Refilling the Water Tank or
Cleaning the VibraRise Mop
Cloth
To add water or clean the VibraRise mop
cloth, press any button to stop the robot
and remove the mopping module. After
adding water or cleaning the VibraRise mop
cloth, reinstall the mopping module and
press the
Sleep
If the robot is paused for over 10 minutes, it
will go to sleep, and the power indicator will
flash every few seconds. Press any button
to wake the robot up.
Notes:
• The robot will not go to sleep when it is charging.
• The robot will automatically shut down if left in sleep
mode for more than 12 hours.
DND Mode
The default Do Not Disturb (DND) period
is from 22:00 to 08:00. You can use the
app to disable the DND mode or modify
the DND period. When DND mode is
activated, the robot will not automatically
resume cleanup, the power indicator
light will dim, and the volume of the
button to
voice prompts will lower.
button to
Child Lock
Press and hold the
disable the child lock. You can also set it in
the app. Once enabled, the robot will not
react to button presses when it is
stationary. When the robot is cleaning or
docking, press any button to stop it.
button to continue.
button to enable/
011
Charging
After cleaning, the robot will automatically
return to the dock to charge.
In Pause mode, press the button to send
the robot back to the dock. The power
indicator will pulse as the robot charges.
Note: If the robot fails to find the dock, it will automatically
return to its starting location. Place the robot on the dock
manually to recharge.
Error
If an error occurs, the power indicator
will flash red and a voice alert will sound.
See "Errors" for solutions.
Notes:
• The robot will go to sleep automatically if left in a
malfunctioning state for over 10 minutes.
• Placing a malfunctioning robot on the dock manually will
end the current cleanup.
System Reset
If the robot does not respond when a
button is pressed or cannot be turned off,
reset the system. Press the Reset button,
and the robot will reset automatically.
Note: After resetting the system, scheduled cleaning, WiFi,
etc. will be restored to factory settings.
Restore Factory Settings
If the robot does not function properly after
a system reset, switch it on. Press and hold
button and at the same time press
the
Reset button until you hear the "Restoring
factory settings" voice prompt. The robot
will then be restored to factory settings.