Ph-Value Settings; Setpoint - swim-tec CL2 Deluxe 2,4 l/h Bedienungsanleitung

26
Page 26
3. pH - value settings
The electrodes must be installed in the control
unit as shown in the above graphic
In the pH menu item, you can change all set-
tings necessary for pH control. Change from
operating mode to set-up mode by pressing the
Mode key. Now press the „arrow up" key until
"pH" appears in the display. Pressing the "OK"
key takes you back to the "pH" sub-menu for
pH control.
Operating mode
Stop
controller
pH
controller
Calibration
pH

Setpoint (1)

SN6 - connec-
7.20
tion for pH
Min. Alarm (1)
electrode
6.80
SN6 - connec-
Max. Alarm (1)
tion for Rx
7.60
electrode
P-band (1)
-1.00
I-reset time (1)
Thread for Rx
0 sec
electrode
D-action time (1)
0 sec
Min. Output (1)
Thread for pH
10 %
electrode
Max. Output (1)
100%
When the option you want to change appears in
the display, press the "OK" key. A star appears
.
in the display. The value can now be changed
using the arrow keys. To save the changed value,
press „OK" again. Cancel by pressing the Mode
key.
Setpoint (1)
7.20
Mode
OK
Sub-menu
You can
scroll
through the
sub-menu by
pressing the
„arrow" keys.
Setpoint (1) *
7.20