Drainage Instructions - Hantech 10474165 Bedienungsanleitungen

— Elongate the exhaust pipe and snap
the flat end of the exhaust pipe
joints into the hole of the window
sealing plate assembly (as shown in
Fig.5 and Fig.6) .
Notes:
— The flat end of the exhaust pipe
joints must be snapped into place.
— The pipe cannot be distorted nor
has substantial turning (greater
than 45 °). Keep the ventilation of
the exhaust pipe not blocked.
Figure 5
Figure 6
Important notice:
The length of the exhaust hose shall
be 280~1,500mm, and this length is
based on the specifications of the air
conditioning. Do not use extension
tubes or replace it with other different
hoses, or this may cause a malfunction.
Exhaust host must be not blocked;
otherwise it may cause overheating.

6. Drainage Instructions

This machine has two drainage
methods: manual drainage and
continuous drainage.
1. Manual drainage:
— When the machine stops after the
water is full, turn off the machine
power and unplug the power plug.
Notes: Please move the machine
carefully, so as not to spill the water
in the water pan at the bottom of
thebody.
— Place the water container below
the side water outlet behind the
body.
— Unscrew the drainage cover and
unplug the water plug, the water
will automatically flow into the
water container.
– 11 –