Hantech 10474165 Bedienungsanleitungen Seite 10

1. Install the heat pipe assembly (as
shown in Fig.1)
Figure 1
— Take out the outer connector
assembly and the exhaust pipe
assembly, and remove the plastic
bags;
— Insert the heat pipe assembly (the
end of the exhaust joint) into the
back panel vent slot (push to the
left) and complete the assembly
(as shown in figure 1).
2. Installation of window sealing plate
components.
— Half open the window, and mount
the window sealing plate assembly
to the window (as shown in Fig.2
and Fig.3).Components can be
placed in horizontal and vertical
direction.
— Pull various components of the
window sealing plate assembly
open, adjust their opening distance
to bring both ends of the assembly
into contact with the window
frame, and fix various components
of the assembly.
3. Install the window sealing plate
assembly.
Notes: the flat end of the exhaust pipe
joints must be snapped into place. 2)
The pipe cannot be distorted nor has
substantial turning (greater than 45 °).
— Keep the ventilation of the exhaust
pipe not blocked.
4. Install the body
— Move the machine with installed heat
pipe and fittings before the window,
and the distance between the body
and walls or other objects shall be
least 50 cm (as shown in Fig.4).
– 10 –
Figure 2
Figure 3
Figure 4