JSP JETSTREAM Bedienungsanleitung Seite 4

Waist-Belt Adjustment
Put the belt around your waist and fasten the two ends together; If the belt is too loose, slide the male adjuster down
the belt, towards the female half. If the belt is too tight, slide the male adjuster away from the female half.
Repeat the above processes until a comfortable and secure fit is achieved. (See Diagram 1)
Once the belt fits correctly, secure any excess belt material using the Velcro sections.
Diagram 1:
Filter Selection
Use only "Jetstream™ and Jetstream™ GV-X" Filters
manufactured by JSP Ltd. (See Diagram 2). It should
first be ascertained by consulting an occupational
hygienist or by calling the manufacturers technical
help line as to whether or not the Jetstream™ Filter
will offer suitable protection from the hazard.
Removing the Filter
Push the Filter-Housing down towards the body of the
Blower Unit and apply a twisting force in a Clock-Wise
Direction. (See Diagram 3) It will now be possible to
pull the filter away from the Unit.
Fitting the Filters
After first having checked the filter for it's sealing gasket and that it's filter element is undamaged (See Diagram 4),
place the filter over the corresponding circular recess in the blower unit. Twist lightly until the 5 location lugs, fall into the
corresponding recesses. (See diagrams 5 & 6.) Force the filter down towards the blower unit and apply a twisting force in
an anti-clockwise direction (See Diagram 7) until the 5-way bayonet system is heard locking into place. (See Diagram 8).
Diagram 4: Jetstream™
FILTER FILTER GASKET GASKET
Diagram 6:
Loosen
FILTER FILTER
Tighten
Diagram 2:
Diagram 3:
Diagram 4: GX-V
GASKET GASKET
Diagram 7:
PUSH DOWN PUSH DOWN
AND TWIST AND TWIST
Jetstream™
PUSH DOWN PUSH DOWN
AND TWIST AND TWIST
Diagram 5:
LOCATION LOCATION
RECESS RECESS
TWIST TWIST
LOCATION LUGS LOCATION LUGS
Diagram 8:
LOCATION LOCATION
LUGS LUGS
LOCKED IN LOCKED IN
GX-V