Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EnGLIsH
SAVE THESE INSTRUCTIONS
Electrical Safety
The electric motor has been designed for one voltage only.
Always check that the power supply corresponds to the voltage
on the rating plate.
If the supply cord is damaged, it must be replaced only by
BLACK+DECKER or an authorised service organisation.
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
•
Safely dispose of the old plug.
•
Connect the brown lead to the live terminal in the plug.
•
Connect the blue lead to the neutral terminal.
•
Connect the green/yelow lead to the earth terminal.
WARNING: We recommend the use of a residual current
device with a residual current rating of 30mA or less.
Follow the fitting instructions supplied with good quality plugs.
Recommended fuse: 13 A.
Using an Extension Cable
If an extension cable is required, use an approved 3–core
extension cable suitable for the power input of this tool (see
Technical Data).The minimum conductor size is 1.5 mm
maximum length is 30 m.
When using a cable reel, always unwind the cable completely.
Package Contents
The package contains:
1 Half sheet sander
1 Instruction manual
•
Check for damage to the tool, parts or accessories which may
have occurred during transport.
•
Take the time to thoroughly read and understand this manual
prior to operation.
Markings on Tool
The following pictograms are shown on the tool:
a
Read instruction manual before use.
g
Wear ear protection.
f
Wear eye protection
Date Code Position (Fig. A)
The date code
12
, which also includes the year of manufacture,
is printed into the housing.
Example:
Year and Week of Manufacture
22
2022 XX XX
Description (Fig. A, C, D)
WARNING: Never modify the power tool or any part of it.
Damage or personal injury could result.
ON/OFF switch
1
Lock‑on button
2
Dust extraction outlet
3
Sanding base
4
Sheet clamp levers
5
Variable speed control knob
6
Dustbag
7
Adaptor
8
Hose
9
Front handle
10
Main handle
11
Date code
12
Intended Use
This half sheet sander is designed for sanding wood, metal,
plastic and painted surfaces.
Do not use under wet conditions or in the presence of
flammable liquids or gases.
Do not let children come into contact with the tool. Supervision
; the
2
is required when inexperienced operators use this tool.
•
Young children and the infirm. This appliance is not
intended for use by young children or infirm persons
without supervision.
•
This product is not intended for use by persons (including
children) suffering from diminished physical, sensory or
mental abilities; lack of experience, knowledge or skills
unless they are supervised by a person responsible for their
safety. Children should never be left alone with this product.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can cause injury.
Fitting Sanding Sheets (Fig. B)
WARNING: Never use the tool without a sanding sheet or
accessory in place.
•
Soften the sanding sheet by rubbing its non‑abrasive side
over the edge of a worktop.
•
Release the sanding sheet clamp levers
•
Place the sheet onto the sanding base
the holes in the sheet line up with the holes in the base.
•
Insert the edge of the sanding sheet into the front paper
clamp as shown.
•
Press the front sheet clamp lever downwards.
•
While keeping a slight tension on the sheet, insert the rear
edge of the sheet into the rear paper clamp.
•
Press the rear sheet clamp lever downwards.
5
.
4
, making sure that
Werbung
Inhaltsverzeichnis
