Electrical Safety - Black & Decker KG900 Anleitung

E N G L I S H
Keep handles and switches dry, clean and free
from oil and grease.
20. Repairs
This tool complies with relevant safety
requirements. Repairs should only be carried
out by qualified persons using original spare
parts; otherwise this may result in considerable
danger to the user.
Additional safety instructions for angle grinders
Wear safety glasses or goggles when
operating this tool.
Wear ear protection when operating this
tool.
Wear gloves when operating this tool.
Do not cut or grind light metal with a
magnesium content exceeding 80%,
since this type of metal is flammable.
Only use grinding and cutting discs and other
x
accessories recommended in this manual.
Make sure that the maximum speed of the
x
grinding or cutting disc exceeds the no-load
speed of the tool.
Do not cut workpieces requiring a maximum
x
depth of cut exceeding that of the cutting disc.
Never use the tool without the guard, except
x
for sanding.
Do not exert side pressure on the grinding or
x
cutting disc.
Use this tool only as a hand held tool.
x
Sanding
Wear a dust mask whenever sanding.
x
Thoroughly remove all dust after sanding.
x
Take special care when sanding paint which is
x
possibly lead based or when sanding some
woods and metal which may produce toxic dust:
- Wear a dust mask specifically designed for
protection against lead paint dust and fumes
and ensure that persons within or entering
the work area are also protected.
8
- Do not let children or pregnant women enter
the work area.
- Do not eat, drink or smoke in the work area.
- Dispose of dust particles and any other
debris safely.
Additional safety instructions for Australia and
New Zealand
This appliance is not intended for use by
x
young or infirm persons without supervision.
Children must be supervised to ensure they do
not play with the appliance.
If the supply cord is damaged, it must be
x
replaced by the manufacturer or an authorised
Black & Decker Service Centre in order to
avoid a hazard.

ELECTRICAL SAFETY

The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
This tool is double insulated in accordance
with EN 50144; therefore no earth wire is
required.
Mains plug replacement (U.K. & Ireland only)
Should your mains plug need replacing and
x
you are competent to do this, proceed as
instructed below. If you are in doubt, contact
an authorised repair agent or a qualified
electrician.
Disconnect the plug from the supply and
x
remove the fuse from the plug.
Cut off the plug and dispose of it safely; a plug
x
with bared copper conductors is dangerous if
engaged in a live socket outlet.
Only fit 13 Amperes BS1363A approved plugs
x
fitted with the correctly rated fuse (1).