Husqvarna 553RBX Bedienungsanweisung Seite 12

To assemble the flexible drive shaft
1. Remove the 2 screws at the shaft coupling.
2. Put the flexible drive shaft through the loops at the
wire harness.
3. Turn and push the flexible drive shaft at the same
time to connect it.
4. Tighten the 2 screws.
5. Assemble the drive shaft sleeve in the clutch cover.
Turn and push the drive shaft at the same time to
connect it.
6. Make sure that the locking pin goes back to its initial
position.
To connect the throttle cable and the
stop switch wires
1. Open the cover.
2. Connect the throttle wire from the wire harness (A)
and the throttle wire (B) from the engine in the cover.
A
3. Close the cover.
12
4. Connect the stop switch wires into the related
connectors from the engine.
To assemble the loop handle
1. Put the loop handle on the shaft.
2. Attach the spacer into the slot in the loop handle.
Attach the nut and the screw. Do not tighten fully.
3. Adjust the product to an applicable work position.
4. Tighten the nut and the screw.
To assemble the J-handle
1. Attach the J-handle to the loop handle with 3 screws.
B
2. Adjust the product to an applicable work position.
3. Tighten the screws.
To assemble the cutting equipment
The cutting equipment includes a cutting attachment and
a cutting attachment guard.
WARNING:
Use the J-handle with
grass blades/grass cutters or trimmer heads/
plastic blades. Do not use saw blades or
clearing blades with the J-handle.
1104 - 009 - 19.05.2022