Manual Operation; Setting The Minute Minder - Klugmann KO608TCP Bedienungsanleitung

USER MANUAL DIGITAL TIMER
SETTING THE TIME OF DAY (24 H
CLOCK)
After plugging in or reconnecting
to a power source after current decay,
"0.00", and "AUTO" flashes.
 Press button 1 approximately
2 sec., dot icon starts flashing. Set the
current time using buttons 2 and 3.
About 7 seconds after the set time has
been finished, new data is memorized.
 The time correction can be done
later;
 Press button
approximately 2 sec., dot icon starts
flashing. Then you can set the current
time.
Notice! If the correct time is not set
then proper operation of the oven is not
possible.

MANUAL OPERATION

If the programmer is not in semi-
automatic or full-automatic mode you
can use oven functions manually.

SETTING THE MINUTE MINDER

You can activate the minute minder
at any time, regardless the activity state
of other programmer functions. The
28
measured time ranges from 1 minute to
23 hours 59 minutes.
 Press button 1 until the minute
minder icon starts to flash, and the
display shows "0.00".
 Enter the required time using
buttons 3 and 2. Minute minder icon
remains on the display.
After the set time has elapsed,
an audible signal will be heard for
approximately 7 minutes and the
minute minder icon starts to flash again.
 Press buttons 1, 2 or 3 to turn
2 and 3
the signal off; the minute minder icon
disappears, and the display indicates
the current time.
CHANGE THE TIMER BEEPS
The tone of the timer beeps may be
changed as follows:
Press buttons 2 and 3 simultaneously,
 Press button 1 to see actual tone
"ton.1" to see on the display.
 Press button 2 to select the tone
you wish from 1 to 3.
CANCEL SETTINGS
Cancel automatic function settings:
Â
simultaneously.
 Cancel minute minder settings:
 Press button 1 to select minute
minder settings,
 Press buttons 2 and 3.
Press buttons 2 and 3
18