TMC Reef Flow 2.0 Installationsanleitung Seite 8

Please note: When making any changes to the Wave Mode settings it is important that
you check and observe the effect any change made will have on your individual aquarium
and make sure that the wave intensity and frequency is suitable for your size aquarium and
its inhabitants.
Please note: In the event of a power cut, your Wave Mode settings will be saved.
5
4
3
2
1
Troubleshooting LED Error Codes
When LED 1 and 2 are flashing: Hardware protection active
• Check motor & check controller
When LED 1 and 4 are flashing: Over voltage detected
• Check PSU
When LED 1 and 5 are flashing: Under voltage detected
• Check PSU
When LED 2 and 3 are flashing: Software protection active
• Check motor & check controller
When LED 3 and 4 are flashing: Open circuit protection
active
• Check all connection cables and powercord to ensure all
are undamaged and connections are correct
• If the above are ok, check the motor
When LED 4 and 5 are flashing: Impeller is jammed or
broken or pump is operating dry
• Check impeller for signs of blockages/damage and ensure
the Reef Flow 2.0 is fully submerged
8