TMC Reef Flow 2.0 Installationsanleitung Seite 5

The Reef Flow 2.0 pumps have been designed to simulate the natural currents found within
the reef environment. Using the supplied controller, you can choose from 3 wave patterns
and adjust the intensity and frequency of your selected wave, to ensure you can create an
environment appropriate for your particular tank and its inhabitants.
Interchangeable nozzle
1 2 3
Mounting magnet (internal)
6
1. Clean the glass where the pump is to be installed.
Please note: the Reef Flow 2.0 can be tilted and angled to your desired position.
Caution: You must ensure that the pump is secured in your desired position before
operating.
2. Submerge the pump completely and then rotate it back and forth to allow any trapped
air to exit the pump impeller housing.
3. Locate the pump in a position at least 15-20cm below the water surface, ensuring
there is adequate space around the pump to avoid resonance, vibrations and substrate
being sucked into the pump. Also make sure the power cable will exit the aquarium in a
convenient place for connecting to the controller.
INTRODUCTION
Impeller
4
Mounting magnet (external)
7
INSTALLATION
5
Motor
5