Technical Data; Specified Conditions Of Use; Additional Battery Safety Warnings - AEG BS18SRABL Übersetzung Der Originalanleitung

TECHNICAL DATA

Type
Production code
Battery voltage
Drilling capacity in steel
Drilling capacity in wood
No-load speed, 1st gear
No-load speed, 2nd gear
Max torque
Drill chuck range
Weight without battery pack
Weight according to EPTA-Procedure 01/2014 (Li-ion 2.0 Ah ... 9.0 Ah)
Recommended ambient operating temperature
Recommended battery types
Recommended charger
Noise Information
Measured values determined according to EN 62841. Typically, the A-weighted noise
levels of the tool are:
Sound pressure level / Uncertainty
Sound power level / Uncertainty
Wear ear protection!
Vibration Information
Vibration total values (triaxial vector sum) determined according to EN 62841.
Vibration emission value / Uncertainty
Drilling into metal
WARNING!
The declared vibration total values and the declared noise emission values given in this instruction manual have been measured in
accordance with a standardised test and may be used to compare one tool with another. They may be used for a preliminary assessment of
exposure.
accessories, keeping the hands warm (in case of vibration), and organising work patterns.
WARNING! Read all safety warnings, instructions,
Failure to follow all instructions listed below may result in electric
for future reference.
RIGHT ANGLE DRILL SAFETY WARNINGS
SAFETY INSTRUCTIONS FOR ALL OPERATIONS
fasteners contacting a "live" wire may make exposed metal parts of
the power tool "live" and could give the operator an electric shock.
SAFETY INSTRUCTIONS WHEN USING LONG DRILL BITS
At higher speeds, the bit is likely to bend if allowed
to rotate freely without contacting the workpiece, resulting in
At higher speeds, the bit is likely to bend if
allowed to rotate freely without contacting the workpiece, resulting in
Bits can bend causing breakage or loss of
16
Cutting accessory or
ENGLISH
4759 10 01 000001-999999
L =71.0 dB (A) / K
pA
L =82.0 dB (A) / K
WA
a
h
ADDITIONAL SAFETY AND WORKING INSTRUCTIONS
Clamp the workpiece with a clamping device. Unclamped
immediately if it stalls. Do not turn on the product again while it is
still stalled, as doing so could trigger a sudden recoil with a high
reactive force. Determine why the product stalled and rectify this,
paying heed to the safety instructions.
The dust produced when using the product may be harmful to
health. Do not inhale the dust. Wear a suitable dust protection mask.
Remove the battery pack before starting any work on the product.

SPECIFIED CONDITIONS OF USE

The right angle drill is intended for drilling and driving screws.
Do not use the product for any other purpose.

ADDITIONAL BATTERY SAFETY WARNINGS

WARNING!
product damage due to a short circuit, never immerse your tool,
chemicals, and bleach or bleach containing products, etc., can
cause a short circuit.
BS18SRABL
Right angle drill
18 V
10 mm
38 mm
0-500 min
-1
0-1900 min
-1
42.4 Nm
0.8 - 10 mm
1.0 kg
1.4 ... 2.2 kg
-18...+50 ºC
L18...
AL18G, BL1...
=5 dB(A)
pA
=5 dB(A)
WA
=2.5 m/s / K=1.5 m/s
2 2