Return To The Initial Settings; Time Setting - HSK Heizstab 4 Betriebsanleitung

Return to the initial settings
You can carry out a general reset to return
to the factory settings:
• the installer settings (grayed out on the
start up menus),
• the time and day,
• set-point temperatures,
• default program.
Turn the dial off, then press the left-hand but-
ton for 10 seconds until "init" is displayed.
Press OK to confirm or C to cancel.
10 sec.
Return to the shutdown mode display.
Time Setting
Day
Hours
Turn the knob to . The days flash. Press +
or – to make your choice, OK to confirm it
and go to the next setting. Repeat the oper-
ations to set the hours and minutes.
Turn the dial to exit the setting mode.
Minutes
49
EN