Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. Before disassembling the heating ele-
ment, please ensure that no damage
can be caused by the heating medium
Disposal
This product should not be disposed of as gen-
eral waste but should be brought to the ap-
propriate collection point for recycling of elec-
tric and electronic devices. This information
is present on the product, user manual and
Troubleshooting
Symptom
LED diode is not on,
heating element does
not heat
LED diode pulsing:
WHITE & RED or
WHITE & YELLOW
LED
TWO
diode
flashes
pulsing
WHITE
(mal-
THREE
function
flashes
alert)
FOUR
flashes
Possible cause
Damaged electronics
The radiator is not
warming up quickly
Low water level (work
in dry conditions)
Overheating
Temperature sensor
damaged
EN
in the radiator (if necessary, empty the
radiator).
on packaging. Information on the appropri-
ate point for used devices can be provided by
your local authority or vendor of the product.
Thank You for your effort towards environ-
ment protection.
Adviced action
contact Your local Distributor
Check and confirm that the heating element's
output is not too low for the size of radiator. The
heating-up phase can take up to 45 minutes.
1. May happen once or twice after switching on –
this is not a malfunction.
2. If lasts longer, check the lever of heating agent
level.
Check and reduce the water temperature in the
central heating system-must not exceed 82°C. Check
and confirm that the heating element's output
does not exceed the recommended output of your
radiator. Turn the heating element off with the ON/
OFF button and wait for 20 min. If the radiator is still
hot, disconnect it from its electrical supply – contact
the Distributor.
Contact Your local Distributor
41
Werbung
Inhaltsverzeichnis
