TFA 30.1009 Bedienungsanleitung Seite 5

TFA_No. 30.1009_usw_Anl_04_22
Digital indoor-outdoor thermometer
For your safety
• Keep this device and the battery out of reach of children.
• Small parts can be swallowed by children (under three years old).
• Batteries contain harmful acids and may be hazardous if swal-
lowed. If you suspect a battery could have been swallowed or oth-
erwise caught in the body, seek medical help immediately.
• Batteries must not be thrown into a fire, short-circuited, taken
apart or recharged. Risk of explosion!
• Low batteries should be changed as soon as possible to prevent
damage caused by leaking.
• Remove the battery if the device will not be used for an extended
period of time.
• Avoid contact with skin, eyes and mucous membranes when han-
dling leaking batteries. In case of contact, immediately rinse the
affected areas with water and consult a doctor.
• Do not expose the device to extreme temperatures, vibrations or
shocks.
1. Getting started
• Pull the protective foil off the display.
• Open the battery compartment by pushing the cover in direction
of the arrow and remove the insulation strip.
• The display shows the current indoor and outdoor temperature.
• Slide the °C/°F switch at the back of the instrument to change
between °C (Celsius) or °F (Fahrenheit) as temperature unit.
8
06.04.2022 8:43 Uhr
Digital indoor-outdoor thermometer
2. Fixing
• Position the thermometer near a window using the built-in hang-
ing slot with a nail or a screw or unfold the table stand.
• Lead the cable with the sensing element through the open window
to the outside. The cable adapts to the window sealing shape. (Take
care of sharp-edged window frames – avoid frequent opening and
closing the window).
• Avoid radiators and direct sunshine.
3. Maximum and minimum values
• Press the MAX/MIN button and the highest and lowest indoor
temperatures are displayed since the last reset.
• Press the MAX/MIN button again, the display shows the highest
and lowest outdoor temperatures since the last reset.
• To go back to the present temperature display, press the
MAX/MIN button once more. The instrument will automatically
quit the MAX/MIN mode if no button is pressed within 15 seconds.
• Press the RESET button while the maximum and minimum values
are displayed to clear the recorded maximum and minimum read-
ings and the actual values appear.
4. Troubleshooting
Problems
No display /
Incorrect display
No display of
outdoor temperature
Seite 5
Solutions
➜ Ensure that the battery
polarity is correct
➜ Change the battery (1,5 V AAA)
➜ Control cable installation
9