Changing A Programme; Cancelling A Programme; Switching The Machine Off - IKEA TALLBODA AA-2326095-4 Bedienungsanleitung

the Rinse Aid Lack Warning Indicator
will illuminate to indicate the rinse aid
chamber needs filling.
NOTE: If you decide not to start
the selected programme, please see
the "Changing a Programme" and
"Cancelling a Programme" sections.

7.1. Changing a Programme

Follow the steps below to change a
programme while in operation.
Open the door and press the
Programme Selection button
to select a new programme.
After closing the door, the new
programme will resume the
course of the old programme.
NOTE: Open the door slightly at
first to stop a programme before it is
complete in order to avoid water spillage.

7.2. Cancelling a Programme

Follow the steps below to cancel a
programme while in operation.
When the door of your
machine is opened, the most
recently selected programme
will be shown on the display.
Press and hold the Programme
Selection button for 3 seconds. At the
end of 3 seconds, '1' will be shown
The water discharge process will start after
the door of the machine is closed and will
continue for 30 seconds. A buzzer will
sound 5 times when a programme is
cancelled.
on the Display.

7.3. Switching the Machine Off

"0" will be shown on the display when a
programme is complete. A buzzer will
also sound 5 times. You can then
switch your machine off using the
Disconnect the plug and
turn off the water tap.
NOTE: Do not open the door before a
programme is complete.
NOTE: Leave the door slightly open
at the end of a wash programme to
speed up drying.
NOTE: If the door of the machine
is opened or the power is cut during
operation, the program will continue
when the door is closed or the power
returns.
Buzzer Sound Control
To change the buzzer sound level,
follow the below steps:
1. Open the door and press Delay (5)
And Options (6) buttons simultaneously
for 3 seconds.
2. When sound setting is recognized,
buzzer gives a long sound and machine
will
display last set level, from "S0" to "S3".
3. To decrease sound level press Delay
button (5). To increase sound level, press
Options button (6).
4. To save the selected sound level, turn
off
the machine.
''S0'' level means all voices are off. Factory
setting is "S3".
Save Power Mode
To activate or deactivate Save Power
Mode, follow the below steps:
GB - 20
Power On/Off button.