Initial start-up
The following message then appears:
✔ Afterwards the AirCon Service Center runs a software test.
✔ Afterwards a leak test is performed.
✔ When the start-up procedure is complete, the AirCon Service Center
displays the following:
I
NOTE
Ignore any error codes which occur during commissioning (see
page 120) and skip by pressing ENTER.
8.3
Standby menu
The standby menu shows you the current supply quantities and the time
settings of the AirCon Service Center.
The following information is shown:
Refrigerant quantity
Fresh oil quantity
UV additive quantity
Time
Date
78
Internal vessel
pressure
Please wait
Software test.
Please wait
Tightness test
Please wait
Refrigerant
PAG oil
UV tracer
11:56:35
KSS Pingo R1234yf
g.
XXXX
ml
XXX
ml
XXX
10/03/20
EN