Cleaning And Maintenance - Team Kalorik TKG VC 1022 Bedienungsanleitung

Using the appliance when not all the filters are installed properly and in good shape might
damage the appliance and invalidates the warranty.
ASSEMBLING THE VACUUM CLEANER
• Always remove the unplug from the socket before fitting or removing accessories !
• Insert the hose connector into the hose connection inlet until it locks. To remove the
hose, press the sides of the hose connector and pull at the hose.
• Fit the tube to the handle of the flexible hose.
• Connect the plastic tube with another plastic tube.
• Fit the tube to the floor brush.
• To remove the accessories, pull firmly apart.
• The appliance is delivered with the following accessories :
Floor brush : ideal for the daily cleaning of carpets and hard floors.
o
Setting with the bristles inside for cleaning carpets.
Setting with the bristles outside for cleaning hard floors.
Crevice tool: for radiators, crevices, corners, baseboards and between cushions.
o
Upholstery brush: for curtains, cushions, edges, doors, mattresses etc...
o
OPERATION
• Pull out a sufficient length of power cord and insert the plug into the power socket.
A yellow mark on the power cable shows the ideal cable length. Do not extend the
cable beyond the red mark.
• Switch on the appliance by pressing the ON/OFF switch with your foot.
• It is advisable to set the electronic power regulator to the minimum position before
switching on the appliance.
By turning the regulator button, the suction power can be adjusted. You can also
adjust the suction power by using the wind-force adjuster on the handle of the hose.
Use a low suction power for furniture and other delicate surfaces and use high
suction power for fitted carpet and other floors.
AFTER USE
• Stop the vacuum cleaner by pressing the ON/OFF switch.
• Unplug the appliance from the power supply.
• Simply press the cable rewind button to activate the cable rewind mechanism.
• The carrying handle can be used to move the appliance.
• Empty the dust collector after each use.
• Clean the filters once a week.

CLEANING AND MAINTENANCE

It is necessary to clean the filters regularly to avoid operating problems.
The filter system consists of:
1 multi-cyclone filter to vacuum the smallest particles (in the dust container)
o
1 air filter, to vacuum the smallest particles
o
Before any cleaning operation switch off the vacuum cleaner and disconnect the plug.
TKG VC 1022 6