Assembling The Vacuum Cleaner; Cleaning And Maintenance - Team Kalorik TKG SKV 1000 Gebrauchsanleitung

Fax +32 2 359 95 50

ASSEMBLING THE VACUUM CLEANER

•
Remove the packaging from the appliance and its attachments.
Your appliance contains following attachments:
−
floor brush
−
crevice tool
−
metal tube with handle
•
The dust collector always has to be attached to the motor unit before using the
appliance. If the dust collector is not mounted, attach it to the motor unit and make sure it
clicks into place.
•
You can assemble the vacuum cleaner in two ways:
1) You can use the appliance without metal tube as handheld vacuum cleaner.
2) Attach the metal tube to the body of the appliance. Make sure that the lug of the
tube enters into the slot of the motor unit and insert the tube until you hear a click
indicating that it is fitted properly. Then you can use the appliance as a stick vacuum
cleaner.
•
Attach the desired suction tool (floor brush or crevice tool) to the nozzle of the dust
collector if necessary.
CAUTION: When using your appliance with the metal tube, you have to hold the appliance by
the handle and avoid pressing on the tube itself, as this could bend or break the tube or the
appliance and this will not be covered by the warranty.
USE
•
When the appliance has been assembled properly, unroll the power cord in order to
obtain the desired length of power cord. Insert the plug into the power socket and switch
on the appliance with the on-off switch.
•
The floor brush can be used for daily cleaning of large surfaces, hard floors or fitted
carpet.
•
The crevice tool can be used for mattresses, couches, curtains or wallpaper. You can also
use this crevice tool to avoid scratching the nozzle of the dust compartment.
•
When using the appliance as a stick vacuum cleaner you can attach the power cord to
the hook of the handle for convenient handling.
AFTER USE
•
Switch off the vacuum cleaner with the on-off switch.
•
Unplug the appliance from the power supply and roll up the power cord.
•
If necessary, disassemble the metal tube and the suction tool used.

CLEANING AND MAINTENANCE

•
Cleaning the filter and the dust collector is extremely important as it allows the optimal use
of your appliance and eliminates the unpleasantness due to bad smells.
•
Remove the dust collector by pressing the release button situated on top of the
appliance. We advise you to do this over a dust bin.
•
Remove the filter and its holder from the dust collector.
•
Empty the dust container and clean it with soapy water if necessary.
•
To clean the filter you can use your ordinary vacuum cleaner or you can shake it or if
necessary wash the filter in lukewarm soapy water. In the last case, rinse it afterwards with
clear water and make sure that the filter is completely dry before re-inserting it in position.
•
Once the filter is clean and dry, put it back in the dust collector. Insert it all the way to the
stop.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
8
Assembly page 8/36
special instruction from
TKG SKV 1000 - 121218
Team