Moun�Ng The Projector - Derksen PHOS 15 LT Nutzungsinformation

4.3. Moun�ng the projector
When you fit the PHOS LT to your power track, you should also connect the projector to the power supply at the same �me.
In the case of a mul�-phase track system, the adapter of the PHOS LT allows a free choice of the phase.T o make things
clearer, the track ligh�ng adapter is shown without the device stand in some cases in the following instruc�ons.
WARNING! Danger of electric shock!
An electric shock can cause serious injury or death.
▶ Only install the device once the mains supply has been switched off.
1. Ensure that the power track has no voltage.
2. The adapter has a bar 3 mm in height on one side,
which has a counterpart in the power track and there-
fore requires precise alignment.
Plug the adapter into the ligh�ng track the right way round,
otherwise the profile will not allow it to fit correctly!
3. Ensure that the lock on the track ligh�ng adapter is in
its lateral home posi�on and the rotary switch for
phase selec�on is in the "OFF" posi�on.
4. Push the correctly aligned adapter into the power
track up to the stop.
PHOS 15 LT
Assambly
✘ ✔
23 / 48