Startup / Operation - BOMANN EBO 7906 Bedienungsanleitung, Garantie

Installing the oven
 Put the appliance with the connecting cable first
into the prepared cabinet a bit.
 Do the connection to the mains, see
connection"
.
 Insert the oven into the cabinet opening com-
pletely. Make sure that the cables do not re-
stricted (bent, squeezed or twisted).
 Attach and secure the oven by using the supplied
screws on the side walls of the cabinet.
Electrical connection
Information for the authorized expert
WARNING:
 The installation to the mains supply must conform
to the local standards and regulations.
 Improper connection may cause to an electric
shock!
 Do not change the appliance plug! Let replace the
mains plug by a specialist if this is not suitable for
the appliance plug.
 Do not use multiple sockets or extension cords.
 Before connecting, ensure that the power supply
corresponds with the information on the rating la-
bel (door frame) and the wiring diagram.
 Connect the mains cable to a properly installed
and earthed wall outlet.
 Arrange the mains cable in such a way that it
does not get in contact with any hot components
of the appliance. Do not lead it over sharp edges
or corners.
 If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
"Electrical
2x mounting holes
are located left and
right in the door
frame.
Connected load
In total, the appliance can take up a rated power of
approx. 2400 W. At this connected load, a separate
supply line for the oven with a 16-ampere fuse is re-
quired.

Startup / Operation

Before initial use
 Clean the oven interior with all therein located ac-
cessories. Follow the instructions that we give you
"Cleaning and Maintenance".
in the chapter
 To burn off possible production residues, heat the
closed oven for approx. 30 minutes at maximum
temperature (240°C_top/bottom heat).
NOTE:
The occurring odor and possibly a slight smoke
development cannot be avoided. So, ensure that
the room is well ventilated during the heating pro-
cess.
Operation overview
The detailed description of the individual controls can
be found in the following sections.
Control panel
1 Oven function selector control
2 Oven temperature selector control
3 Oven temperature control lamp
4 Digital timer with LED display
Function selector control
The function selector control is used to set the heat-
ing mode. To set a function, turn the control to the
symbol with the desired heating mode.
27