Startup / Operation - BOMANN EBO 7908 IX Bedienungsanleitung, Garantie

Electrical connection
Information for the authorized expert!
WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
shock!
• Do not change the appliance plug! Let replace the
mains plug by a specialist if this is not suitable for
the appliance plug.
• Do not use multiple sockets or extension cords.
• Before connecting, ensure that the power supply
corresponds with the information on the rating la-
bel (door frame) and the wiring diagram.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• Arrange the mains cable in such a way that it
does not get in contact with any hot components
of the appliance. Do not lead it over sharp edges
or corners.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Connected load
In total, the appliance can take up a rated power of
approx. 2350 W. At this connected load, a separate
supply line for the oven with a 16-ampere fuse is re-
quired.

Startup / Operation

Before initial use
• Clean the oven interior with all therein located ac-
cessories. Follow the instructions that we give you
"Cleaning and maintenance".
in the chapter
• To burn off possible production residues, heat the
closed oven for approx. 30 minutes at maximum
temperature (250°C_top/bottom heat).
NOTE:
The occurring odor and possibly a slight smoke
development cannot be avoided. So, ensure that
the room is well ventilated during the heating pro-
cess.
Operation overview
The detailed description of the individual controls can
be found in the following sections.
Control panel
1 Function selector control
2 Operating control lamp
3 Temperature selector control
4 Temperature control lamp
Function selector control
The function selector control is used to set the heat-
ing mode. To set a function, turn the control to the
symbol with the desired heating mode.
Operating control lamp
The control lamp indicates the oven operation.
Temperature selector control
CAUTION:
Only turn the temperature selector control clockwise
and back again. Otherwise, the control will be dam-
aged.
The temperature selector control is used to set the
oven temperature. The thermostat allows tempera-
ture setting in the range from 50°C to 250°C.
Temperature control lamp
The control lamp indicates heating operation.
If the light goes out, the set oven temperature has
been reached.
23