Installation; Storing Telephone Numbers - Konig Electronic SEC-AED10 Anleitung

Telephone Dialer with panic button
Introduction:
Security alarm system with built-in telephone dialer for emergency situations. Pre-programmable
telephone numbers and intercom function. Ideal for people living alone or for other situations when
help is required.

Installation:

1) Open the battery compartment and place 4x AAA batteries (for back-up) according the right polarity.
The red LED indicator will light up if the batteries have low capacity. Replace the batteries.
2) Connect the supplied telephone cable to the unit and the two way splitter. Connect your telephone
also to the splitter. Connect the AC/DC adapter to the unit and a wall outlet.
3) Switch "ON" the unit with the ON/OFF switch. The red LED will flash for 15 seconds.
Note: if the unit is turned "OFF" the personal code, recorded message and stored telephone numbers
will not be lost.

Storing telephone numbers:

Store up to 3 telephone numbers, after finishing above process.
Inform the people who's telephone number is programmed and explain that if an emergency call is
received they can open two-way communication (intercom) by pressing one of the numeric keys on
their telephone.
Follow below procedure for storing telephone numbers.
1st set:
+ telephone number +
ENGLISH
2