After Ironing; Cleaning And Maintenance - Ufesa PV3600 almeria Bedienungsanleitung

AUTO SHUT-OFF FUNCTION
(model dependent)
The auto shut-off function switches off the iron when it is left unattended, thus increasing security and
saving energy.
1. Plug in the iron.
Initial heating up process: this function will be inactive for the first two minutes in order to give the
appliance time to reach the set temperature.
The safety circuit will switch the appliance off automatically and the indicator light (11*) will start flashing
in the following cases:
If the iron is not moved for 30 seconds while resting on its soleplate or on its side.
If the iron is not moved for 8 minutes while in the upright position.
To reconnect the iron, just move it about gently.

AFTER IRONING

1. Unplug the iron from the mains socket.
2. Empty the tank. Hold the iron with the point down and shake lightly.
3. Switch the steam regulator (3) from "0" to and back again several times (self- cleaning).
4. Set the steam regulator to the "0" position.
5. Allow the soleplate (8) to cool down.
When storing the iron:
Lean the iron standing on the rear cover, not on the soleplate!
Do not wrap the power cord too tight!

CLEANING AND MAINTENANCE

Attention! Risk of burns!
Always unplug the appliance from the mains supply before carrying out any cleaning or maintenance
operation on it.
1. If the iron is only slightly soiled, pull out the plug and allow the soleplate (8) to cool down. Wipe the
housing and the soleplate with a damp cotton cloth only.
2. If the cloth is synthetic, it may melt due to the high temperature on the soleplate. Rub off any residue
immediately with a thickly folded, damp cotton cloth.
3. To keep the soleplate smooth, you should avoid hard contact with metal objects. Never use a scouring
pad, or chemicals to clean the soleplate.
DESCALING SYSTEMS
SELF-CLEAN
Each time you use the steam regulator (3), the system cleans the mechanism of scale deposits.
ANTI-CALC SYSTEM
The anti-calc cartridge has been designed to reduce the build-up of scale produced during steam ironing,
helping to extend the useful life of your iron. Nevertheless, the anti-calc cartridge cannot remove all of
the scale that is produced naturally over time.
Note: do not use chemical additives, scented substances or decalcifies. Failure to comply with the
mentioned conditions leads to the loss of guarantee.
21