BH Tecnovita X.Forte YF88 Montage- Und Gebrauchsanleitung Seite 15

All manuals and user guides at all-guides.com
FITTING THE LEG SUPPORT
To unfold the unit, follow steps 1-5 given in the previous section.
First, take the round tube with smaller foam pad and insert it into one of the three
hole positions on the longer leg support tube (13). Then fit the smaller foam pad
onto the other side of the round tube. Now carry out the same procedure for the
round tube with the larger top foam pads for the leg support (13), inserting it into
the smaller support. .
Next, take the two leg support tubes with the foam pads and connect them by
lining up the holes and inserting the lock pin so that the hook on the longer tube,
marked with an arrow, faces outward.
Now insert the leg support (13) onto the leg support connection plate (16),
securing it by means of the lock pin on the plate. The hook is used to connect the
ring of one or more of the three red elastic resistance bands.
UNFOLDING THE UNIT.-
To unfold the unit, first place it on a flat surface (Fig 1) and remove the cover (12)
(Fig 2). Use one hand to take the unit by the handle (Fig 3) and use the other hand
to open it on the side that has the wheels (armless support) (Fig 5). Adjust the
position of the seat (Fig 6)
15