Filling With Water; How To Use - Ufesa GS1700 Bedienungsanleitung

FILLING WITH WATER

Remove the mains plu from the wall socket before fillin (or emptyin ) the arment.
STEAMER WITH WATER
Press the 2 buttons at the same time to remove the water tank and pull out the water tank.
Remove the water inlet stopper. Fill the water tank with a maximum of 220 ml of untreated tap water.
Your appliance was desi ned to operate usin untreated tap water.
Do not use pure demineralised or pure distilled water, water from clothes dryers, scented or softened
water, rain water, filtered, bottled or boiled water, water from refri erators, batteries or air conditioners as
these may dama e the appliance. These types of water contain or anic waste, mineral elements that
become concentrated when heated and cause spittin , brown stainin , leakin or premature wear on
your appliance. If your water is very hard, mix 50% untreated tap water with 50% distilled water.
Close the water inlet stopper.
Return the water tank to its place on the appliance then plu it in.

HOW TO USE

Before the usin please check the fabric´s label for recommendations.
We recommended that you test acrylic, nylon or other synthetic fabrics in an inconspicuous area to
ensure these fabrics are not dama ed by hot steam.
Use a clothes han er to iron your clothes.
Plu -in the appliance, a blue li ht will twinkle on the base. Turn it on by pressin the on/o switch. A red
li ht will twinkle on the button and the blue li ht on the base will chan e to bri ht. Wait until the li ht stop
twinklin and chan e to bri ht, meanin you can use the hi h power steam (approximately 20 seconds).
Press a ain and the li ht will chan e to blue, for smaller power steam. If pressed a ain the product will
stop operatin and the blue li ht will twinkle on the base. Once selected the hi her or lower power steam
you can use the product by pressin the steam button.
Press the steam button with the steam brush facin away from you holdin it in a vertical position. For
optimal use, pass the steam jets over your arment from top to bottom.
As steam is very hot: never attempt to remove creases from a arment while it is bein worn, always
han arments on a clothes han er.
The fabric brush opens the weaves of the fabrics for better steam penetration. Before removin or
attachin the steam brush, unplu your appliance and allow it to cool down.
Durin use or while unit is heatin or coolin do not rest appliance on its head. Place the product on a
stable, heat resistant, flat surface, as the head will be hot. As the appliance heats, the housin becomes
warm. This is normal.
Remove the main plu from the wall socket. Wait for an hour for your appliance to cool before storin .
15