Dab Radio Mode - Sharp DR-P420 Bedienungsanleitung

Change the mode
Short press to change between DAB, FM, and
Bluetooth modes. The display screen will confirm
the mode.

DAB radio mode

Select DAB radio mode
Short press until the screen displays <DAB+>.
The first time you use the radio or if the station list
is empty, your radio will automatically begin to scan
for DAB radio stations. A progress bar will show the
progress of the scan and the number of stations
found during the scan will also be displayed. If you
were listening to a DAB station when you switched
the radio off, this station will automatically be
selected when you switch the radio back on.
Change DAB stations
Use and to scroll through the available
stations. Press to select when the station you want
to listen to is displayed. There will be a short delay
whilst your radio tunes to your selected station.
Scanning for DAB stations
With DAB radio, additional stations and services
regularly become available. Carry out a manual scan
periodically to make sure that you have the most
up-to-date station listing stored within the memory
of your radio. If you have moved your radio to a new
location, for e.g., if you go abroad on holiday, then it's
also a good idea to carry out a manual scan.
In DAB mode:
Long press . Use
select <Full Scan>. The display will change to
<Scanning...>. A progress bar will show the progress
of the scan and the number of stations found.
Prune DAB stations
You can remove the DAB stations in the station list
that cannot be received in your area. These are listed
with a <?> prefix.
EN
to scroll and