Sleep Timer - Sharp DR-P420 Bedienungsanleitung

Note: If the time is not set or has failed to update
from the radio signal, <Time is not set> will be
displayed when you try to set the alarm. The radio will
then prompt you to set the time. An alarm can only
be set after the time has been set.
If you try to set alarm when the unit is powered by
batteries, <Alarm inactive> will be displayed. Alarm
functions are only available with mains power (USB).
Stop, snooze, or switching the alarm
off
To stop the alarm, short press
will be displayed. The alarm symbol will remain in the
display and will sound again at the same time the
next day unless it was set for <Once>.
To snooze the alarm, press
displayed, followed by a 10-minute countdown. Once
the countdown ends, the alarm will sound again. You
can terminate snooze by pressing
will be displayed.
To switch off the alarm, follow the steps for 'Set an
alarm' and select <Off>.
,<Alarm off>
. <Snooze> will be
. <Alarm off>

Sleep timer

You can set your radio to switch to standby mode
automatically using the sleep timer. You can choose
from <Sleep off>, <15>, <30>, <45>, <60> and
<90> minutes. To do this, long press
to scroll and select <System> / <Sleep>.
Use to scroll and select your preference.
<Sleep> will be displayed. In the top right of the
radio display, the number of minutes until your radio
will switch to standby mode will be displayed e.g.,
S90.
Display backlight timeout
To adjust the display backlight timeout, long press
. Use to scroll to and select <System>
/ <Backlight> / <Timeout>. Scroll through the
available backlight timeout options. The current
setting will have an asterisk (*) in the display. Press
to select.
Similarly, use
the backlight brightness for the <Dim level> and
<On level>. There are 3 options available: <High>,
. Use
to change the settings for
EN