Ferm 326120 Gebrauchsanweisung Seite 3

SPARE PARTS LIST
REF.NR. DESCRIPTION
01 +02 RUBBER FOOT COMPLETE
03 ENCLOSURE COMPLETE
05 SWITCH
06 ROTOR
08 STATOR
09 + 10 + 11 CARBON BRUSHSET + HOLDER
17 + 22 SANDING PAD COMPLETE
28 FAN
DUST BAG
42
PRODUCT INFORMATION
FERM NR.
408450
408451
408452
408243
408244
408245
408453
408252
408249
Fig. A.
The FBF-8E router has been designed for professional
routing of wood, wood products and plastics.
1 on/off switch
2 handle
3 router base
4 locking bolt for parallel guide
5 opening for parallel guide
6 collet nut
7 spindle lock
8 revolver-depth stop
9 locking bolt depth stop
10 depth stop
11 clamping lever
12 scale cutting depth
13 adjusting wheel electronic speed control
Ferm Ferm
MOUNTING ACCESSORIES
Fig. B.
Prior to mounting an accessory always unplug the tool.
Mounting and removing cutters.
Only use cutters with a shaft diameter which corresponds
with the size of the collet. Only use cutters which are suited
for the maximum speed of the machine. The cutter diame-
ter should not exceed the maximum diameter (see 'Tech-
nical specifications').
• Press the spindle lock (7) and turn the collet nut (6) until
it engages in the lock. Keep the spindle lock pressed
during this procedure.
• Open the collet nut using the wrench.
• Place the cutter shaft in the collet.
• Tighten the collet nut so that the cutter is locked pro-
perly.
• Open the collet nut when you want to replace a cutter.
Wait until the machine has come to a complete
standstill and the cutter has cooled down before
replacing a cutter.
3