Renson Healthbox 3.0 Anleitung Seite 129

➋
Ø125
Ø150
Ø125
Ø80
➌
➍
• You are now ready to start the system (section 13).
• You can use adapter/cap Ø125-80 for different
functionalities:
1. Seal the unused supply points.
2. Coupling piece between control module and flexible/air
duct. Cut off the cover according to the matching groove
on the adapter:
– Ø125 — > Ø80: if a channel Ø80 must be connected.
– Ø125 — > Ø125: if a channel Ø125 must be connected.
• Air extraction adapter Ø125-150
Use the supplied air extraction adapter Ø125 — > Ø150 to
connect a Ø150 bleed line. The air extraction adapter is
eccentric. An air duct Ø160 can also be easily connected
via the optional rubber ring (available separately).
• Connect the air duct works flexibly to the adapter pieces by
using the supplied straps.
• Connect each room/zone(s) to the appropriate control
module (section 10.2).
• ➔ Make sure that the power supply is switched off!
• Remove the cover plate from the Healthbox 3.0.
• Follow the instructions to make all electrical connections
(section 12.6).
• Fit the cover plate back onto the fan unit.
Healthbox 3.0
®
129
en