Makita 9565CLR Bedienungsanleitung Seite 4

ENGLISH (Original instructions)
1-1. Shaft lock
2-1. Slide switch
3-1. Indication lamp (speed adjusting
dial)
4-1. Speed adjusting dial
7-1. Abrasive disc
7-2. Pad
7-3. Spindle
9-1. Head cover
9-2. Gear housing
10-1. Screw
SPECIFICATIONS
Rated speed (n) / No load speed (n
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for grinding, sanding and cutting of
metal and stone materials without the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode : surface grinding
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Explanation of general view
12-1. Wheel guard
12-2. Bearing box
12-3. Screw
13-1. Lock nut
13-2. Depressed center grinding
13-3. Inner flange
14-1. Lock nut wrench
14-2. Shaft lock
15-1. Marking A
16-1. Marking B
Model
Abrasive disc
Spindle thread
)
o
Overall length
Net weight
Safety class
) : 86 dB(A)
pA
) : 97 dB(A)
WA
2
) : 4.5 m/s
h,AG
2
wheel/Multi-disc
ENE048-1
Work mode: disc sanding
Vibration emission (a
Uncertainty (K) : 1.5 m/s
ENF002-1
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
The declared vibration emission value is used for
•
main applications of the power tool. However if the
ENG905-1
power tool is used for other applications, the
vibration emission value may be different.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
ENG900-1
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
4
17-1. Marking C
18-1. Pin
18-2. Vent
20-1. Lock nut
20-2. Abrasive cut-off wheel/diamond
wheel
20-3. Inner flange
20-4. Wheel guard for abrasive cut-off
wheel/diamond wheel
21-1. Exhaust vent
21-2. Inhalation vent
9565CLR
125 mm
M14
-1
2,000 - 7,800 min
311 mm
1.9 kg
/II
2
) : 2.5 m/s or less
h,DS
2
ENG902-1