Fein STS325R Handbuch Seite 14

OBJ_BUCH-0000000098-001.book Page 14 Wednesday, March 6, 2013 1:56 PM
en
14
en Original Instructions for Compressed Air Hacksaw.
Symbols, abbreviations and terms used.
Symbol, character Explanation
Make sure to read the enclosed documents, such as the Instruction Manual.
Observe the instructions in the text or graphic opposite!
Do not touch the saw blade.
Disconnect the energy supply prior to this workstep. Otherwise there may be danger of injury
caused by unintentional starting of the pneumatic tool.
Use eye protection during operation.
Use ear protection during operation.
Use protective gloves during operation.
Additional information.
Gripping surface
Confirms the conformity of the pneumatic tool with the Guidelines of the European Commu-
nity.
This sign indicates a possible dangerous situation that could cause severe or fatal injury.
WARNING
Worn out pneumatic tools and other electro-technical and electrical products should be col-
lected separately and sorted for environment-friendly recycling.
Product with double or reinforced insulation
Steel
Low stroke rate
High stroke rate
Character Unit of measurement,
international
P
W
2
-1
n
/min, min , rpm, r/min
0
p bar
Vol.
l/min
mm
M...
mm
Ø mm
mm
mm
mm
kg
L dB
pA
L
dB
wA
L dB
pCpeak
Unit of measurement, Explanation
national
W Output
rpm Stroke rate at no-load
bar Pressure
l/min Flow rate
mm Stroke length
mm Size of metric thread
mm Diameter of a round part
mm Hose diametre
mm Maximum outside diameter for pipes/with chain
extension
mm Maximum work piece dimensions
kg Weight according to EPTA-Procedure 01/2003
dB Sound pressure level
dB Sound power level
dB Peak sound pressure level