Bresser ClimaTrend Life Bedienungsanleitung Seite 14

5.
6.
7.
8.
Remote sensor
9.
10. Insert the batteries into the battery compartment. En-
11. Set the channel selector switch to the desired channel.
12. Replace the battery compartment cover.
14 / 60
NOTICE! For permanent operation, mains power
supply is recommended. Alternatively a power sup-
ply with batteries is also possible, to keep the time
setting in case of power failure. Proceed as follows:
Remove the battery compartment cover.
Insert the batteries into the battery compartment. En-
sure that the battery polarity (+/-) is correct.
Replace the battery compartment cover.
Wait until the indoor temperature is displayed on the
base station.
NOTICE! When switching from mains power supply
to battery power supply or vice versa, the power
supply is being disabled for a short moment for
technical reasons. Exception: permanent battery op-
eration.
Remove the battery compartment cover.
sure that the battery polarity (+/-) is correct.
NOTICE! This weather station can be operated with
one or more remote sensors. Each remote sensor
being connected must be operated on a different
channel. If only one remote sensor is connected, it
should be operated on channel 1.