Power Supply Via Mains Adapter; Disconnecting The Power Supply - Walimex Pro LED Niova 100-F Pro 100W Bi Color Gebrauchsanleitung


Avoid completely discharging your battery (exhausting the
battery) and recharge it as soon as possible. This will ensure
the long-lasting functionality and performance of your battery.

20.2 Power supply via mains adapter

1. Switch off the device. To do this, set the on/off switch (25) to
the [0 OFF] position.
2. Plug the round plug (33) of the supplied power supply unit
(32) into the power socket (27) marked [DC 13-19V] on the
back of the lamp. Make sure that the orientation is correct.
3. Screw the locking collar of the plug onto the thread of the
socket.
4. Connect the mains adapter (32) to the mains cable (34).
5. Connect the mains cable (34) to a grounded socket of the
local mains supply (AC 100-240V / 50/60 Hz, see chapter 25).
Only operate the luminaire if the connection values match the
local power supply.
6. To switch on, set the on/off switch (25) to the [II ADAPTER]
position.

20.3 Disconnecting the power supply

Switch off the lamp after use.
Battery operation: Remove the battery from the battery dock (12) by
pressing the according release button (13).
Power supply operation: Disconnect the device from the mains if
you are not going to use it for a longer period of time. To
disconnect the power supply, proceed in reverse order as described
in chapter 20.2. First disconnect the mains plug from the mains, then
from the power supply unit, then the round plug from the lamp.
Manual 23091 LED Niova 100-F Pro 100W Bi Color
46