Speed Setup - Sony KLH-W32 Bedienungsanleitung

IP Address Setup

Speed Setup

Note
"IP Address Setup" and "Speed Setup" are not available if the optional adaptor with communication functions is not installed.
28
GB
Sets an IP address to enable the communication between the optional adaptor with
communication functions, such as the BKM-FW32/FW50, installed in the display,
and the equipment such as a PC connected with the LAN cable.
"DHCP": "OK" allows you to set an IP address automatically, and "Cancel" aborts
automatic configuration.
Note
When you obtain an IP address automatically using "DHCP", an IP address may differ every
time you turn the power of the display off and on.
"Manual": Select to set an IP address manually.
Select an "IP Address", "Subnet Mask", "Default Gateway", "Primary DNS"
1
"Secondary DNS" to be set manually with
Set the three digit value (0 to 255) for the first box with
2
numeric keys on the remote control and press
Set the three digit value (0 to 255) for each of the four boxes and press
3
Select the next item to be set manually with
4
procedure and press
After values are set for all the desired items, select "Execute" with
5
press .
Select "OK" and press
Note Note
When an IP address is not set properly, the following error codes will be displayed in
accordance with the error cause.
Error 1: Communication error between the display and the optional adaptor such as the BKM-
FW series
Error 2: The specified IP address is already used for other equipment
Error 3: IP address error
Error 4: Gateway address error
Error 5: Primary DNS address error
Error 6: Secondary DNS address error
Error 7: Subnet mask error
Sets a communication speed between the optional adaptor with communication
functions, such as the BKM-FW32/FW50, installed in the display, and the
equipment such as a PC connected with the LAN cable.
"Speed": Select "Auto" when you want to set an appropriate communication speed
for your network configuration automatically. You can also select either of "10Mbps
Half", "10Mbps Full", "100Mbps Half", "100Mbps Full" manually.
"Execute": Select "OK" and press
V v
/
V
/
.
. An IP address is set manually.
. A communication speed has been set.
and press .
V v
/ on the display or
or b .
v
and repeat the same
V v
/
.
, then