How To Operate (With Timer Operation); Setting The Current Time - Panasonic CS-W24BD2P Bedienungsanleitung

4-3 How to operate
*
Set the clock and other operation details (refer to page 7 for operation setting details) before setting the timer.
AIR SWING TIMER
LOCAL
OFF / ON
TIMER
SELECT
SET
TEST RUN CLOCK CANCEL
Setting timer operation
Timer operation can be used to start and stop the indoor unit automatically.
To set the OFF timer
Press C to activate the OFF time setting.
1
The current time will flash and OFF will appear in
the display.
(Example)
TIMER
OFF
• The display will switch from OFF to ON to current time
accordingly by pressing the SELECT button.
2 Press B to set the timer.
To set a later time, press the L button.
To set an earlier time, press the M button.
Setting is possible within the range of 0:00 to
23:50, in interval of 10 minutes.
The setting changes more rapidly if the buttons
are pressed continuously.
Press D to complete the settings.
3
(Example)
TIMER
OFF
(with timer operation)
OPE-
FAN
RATION TEMP
SPEED
MED
COOL
FAN OPE- TEMP
UP
SPEED RATION
DOWN
FILTER
CHECK A/C No.
RESET
(The display shows an
example of operation stops
at 23:00)

Setting the current time

Example: setting the time to 10:36 a.m.
Press A to activate the setting time.
1
(Example)
2 Press B to set the desired time.
To set a later time, press the L button.
To set an earlier time, press the M button.
The setting changes more rapidly if the buttons
are pressed continuously.
Press A once more to complete the settings.
3
(Example)
To set the ON timer
Press C until ON display and the time
1
flashes.
2
Repeat step 2 and 3 of procedures "To set the
OFF timer" to complete the ON time settings.
NOTES
• If both ON and OFF timers are set, the time nearer to the
current time will be activated first.
• To cancel the timer setting, press the CANCEL button.
• If the main power is switched off for an hour, the time and
timer will need to be set again.
• If the setting procedures are not completed within 1
minute, the setting will be cleared automatically.
– 8 –
(Time display will flash.)
TIMER
(The time display will stop
TIMER
flashing.)