welltherm RL0606 Bedienungsanleitung Seite 14

V3.5 28.07.2014
Step 2
Hold the drilling template on the wall/ceiling and orientate it by using a water
level.
Step 3
Mark the 4 drill positions (Please note that only the upper holes of the drilling template are relevant for wall mounting).
Tip: Before drilling the holes please check if there no tubes or wires are present in this area. Use a suitable metal detector.
Step 4
Drill the 4 holes by using a Ø6mm drill (depth=length of the dowel').
The depth of the holes should not differ much from the dowel length (50mm).
To ensure this demand please mark the drill or use a depth stop.
Tip: To avoid the formation of dust it is recommended to use a vacuum cleaner
simultanously.
Step 5
Push the dowels in the holes and screw the screws in. The distance between the heads of the srews and de dowel should be about 2,5 to
3mm!
Step6
Hang the heater to the 4 screws. The heating panel has to be moved on the wall in a way that the
screw will be positioned on the upper point of the groove (red marked circle in the picture below).
The panel heater is fixed on the wall now.
1. Hang the heater to the screw heads
GB
2. Move the heater down
3. Move the heater to the side
Manual_ESG_DE_GB_Rev. 3.5 | Welltherm
4. Move the heater down again
(final position)
14