Introduction; General Information; Intended Use; Waste Management - welltherm RL0606 Bedienungsanleitung

V3.5 28.07.2014

2. Introduction

Dear customer,
Thank you very much for purchasing our product.
This Welltherm infrared heater was developed and produced carefully.
In this manual you will find important information on how to start running your Welltherm infrared heater.
The Welltherm infrared heater will satisfy you by easy installation, flexibility in mounting and it is maintenance free.
Please read this manual carefully before you get started for your safety.
Hold this manual in reach and don't forward the infrared heater without this manual!
Thank you for your trust!

3. General information

The heating element will not work as a conventional convection heater for it uses the infrared heat. With energizing the heater for the first time the
cold surroundings (ceiling, floor, furniture, walls) have to be heated up first. If you will not get a pleasant temperature directly please hold the heater
energized until you will get a convenient indoor climate. This process can last some hours up to some days. When all solid frames are warmed up
there will be a comfortable temperature in the room.
With this condition the turn on time of the heater can be reduced to minimum.
For an efficient and effective control of your Welltherm infrared heater we recommend the use of our quality wireless thermostates. Please contact
us for further information.

4. Intended use

The Welltherm infrared heating panels are due to be used as wall or ceiling heater (see first side).
Please note that the notice of this manual is part of the intended use.
Please don't use the heater for outdoor purposes. Also the heater is not suitable for rooms where it is exposed to water and for all applications
which are not explicitly named intended use.
The Welltherm infrared panel and the power outlet must not be mounted in the protection zone 0, 1, 2 of plumbed rooms.

5. Waste management

6. scope of delivery

The delivered contents consists on heating panel, drilling template and standard mounting set.
The delivered dowels UX6 and screws 6x45 are suitable for normal brickwork made of beton, clay bricks and lime stone. With different brickwork
the suitability of the fixation material has to be ensured. When you are not sure about that please get in touch with a specialized dealer for towels
and screws. For ceiling mount a ceiling mount set is optional available!
®
4 x Spax 6 x 45 4 x UX6
7. Cleaning and care on Welltherm infrared panel heaters
A frequent cleaning of the panel heater will ensure faultless operation and a long lifetime circuit of your infrared panel heater. Please switch off the
heater and cool it down to room temperature before you clean the surface. For cleaning use a wet cleaning cloth or glass cleaner. Don't use any
abrasive powder cleaner or furniture polish for this will damage the surface.
GB
Please depollute the package material and the device according to its specification.
Electrical equipment contents recources as also polluting materials. Therefore it has to be disposed of as hazardous
waste.Follow your regional regulations.
1 x drilling template
Manual_ESG_DE_GB_Rev. 3.5 | Welltherm 12